DIRECTIONS FOR UBER GOOP (LIQUID PVC)
MAKE SURE YOU HAVE ADEQUATE VENTILATION BEFORE USING andplease follow these instructions.
Uber Goop Rack plastic paint Rack Repair for welded joints
1.Scrape/sand as much rust and loose rack coating off affected areas as possible. Use a medium grade sandpaper to rough up the surface of the existing rack coating next to the bare metal and wipe it with rubbing alcohol, allowing the Uber Goop to adhere better.
NOTE: It is recommended you overlap the Uber Goop onto the existing
coating about 1⁄4 inch for a better seal.
2.Spread on goop, ENCIRCLING the wire. Let dry 1 hour. Put 2nd coat on and let dry 1 more hour.
NOTE: Uber Goop dries QUICKLY. Replace cap IMMEDIATELY after
use. Also, to help the goop last, slide thumb over bottle opening each time you pull the brush out. If you get an accumulation of drying goop along the stem of the brush you can wipe it off with a paper towel then replace brush and close tightly.
Uber Goop for Tine Repair with vinyl caps
3.Make sure as much rust as possible has been removed from tines. Again, rough up the old coating and clean with rubbing alcohol as in step 1 above.
NOTE: If the tip of the tine is TOO rusted....you might want to simply cut part of it off with wire cutters to blunt the end...then glue on the cap.
4. Turn the rack UPSIDE DOWN and DIP the tines into the bottle covering about a quarter inch...then immediately put on the cap. You can coat 2 or 3 tines and then slide on the caps. Let tines dry 2 hours.
NOTE: CAPS WILL NOT STAY ON TINES DURING WASH IF NOT GLUED.
NOTE: UBER GOOP can be thinned with acetone if needed.